Electrolux IK2065S Notice D'utilisation page 66

66 www.electrolux.com
Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the Fast‐
Freeze,FastCool or after
changing the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig‐
erator.
Water flows on the floor.
Possible cause
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
Solution
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "FastFreeze func‐
tion".
Refer to "FastCool func‐
tion".
Refer to "Closing the door".
Position the water drain‐
age plug in the correct
way.
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.