Control Panel - Panasonic EYFLC1A Instructions D'utilisation

CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit comes
to a complete stop.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
. Depress the trigger switch slightly to start
the tool slowly.
3. The speed increases with the amount of
depression of the trigger for efficient tight-
ening of screws. The brake operates and
the bit stops immediately when the trigger
is released.
4. After use, set the lever to its center posi-
tion (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation. Check the
direction of rotation before use.
. Depress the trigger switch slightly to start
the tool slowly.
3. After use, set the lever to its center posi-
tion (switch lock).
CAUTION:
• To eliminate excessive temperature
increase of the tool surface, do not
operate the tool continuously using two
or more battery packs. Tool needs cool
off time before switching to another
pack.
Cautions for Cordless
Oilpulse Driver
This tool is a hydraulic industrial tool which
generates torque by using oil viscosity.
Since oil viscosity changes according to
the temperature, be aware of the points
below while operating.
• The automatic power-off function will
activate and stop tool operation if the
oil becomes too hot, regardless of the
remaining battery life.
• Torque may decrease significantly
when the automatic power-off function
is activated due to high oil temperature.
Check the torque.
• When the automatic power-off function
is activated, performance will return
to normal after the tool has sufficiently
cooled (approximately 30 minutes or
more).
• Avoid work which causes the automatic
power-off function to activate repeatedly.
• When the temperature of the tool is
low, the tightening strength may not
be sufficient at the beginning of use.

Control Panel

(3)
(1) LED light
Before the use of LED light, always pull the
power switch once.
Press the LED light on button.
The light illuminates with very low current, and
it does not adversely affect the performance of
the tool during use or its battery capacity.
CAUTION:
• The built-in LED light is designed to illu-
minate the small work area temporarily.
• Do not use it as a substitute for a regu-
lar flashlight, since it does not have
enough brightness.
• LED light turns off when the tool has
not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
- 7 -
() (1)