Attaching Or Removing Bat­ Tery Pack - Panasonic EYFLC1A Instructions D'utilisation

Symbol
V
n
0
... min
-1
reciprocations per minutes
Electrical capacity of battery
Ah
injury, user must read and
IV
. ASSEMBLY
Attaching or Removing Bit
NOTE:
• When attaching or removing a bit, dis-
connect battery pack from tool or place
the Forward/Reverse lever in the center
position (switch lock).
1. Hold the collar of quick connect chuck and
pull it out from the tool.
. Insert the bit into the chuck. Release the
collar.
3. The collar will return to its original position
when it is released.
4. Pull the bit to make sure it does not come out.
5. To remove the bit, pull out the collar in the
same way.
CAUTION:
• If the collar does not return to its original
position or the bit comes out when pulled
on, the bit has not been properly attached.
Make sure the bit is properly attached
before use.
9 mm – 9.5 mm
1 mm
(15/3") (3/64" – 3/8")
Meaning
Volts
Direct current
No load speed
Revolutions or
pack
To reduce the risk of
understand instruction
manual.
6.35 mm
(1/4")
Attaching or Removing Bat­
tery Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks into
position.
Alignment
marks
. To remove the battery pack:
Pull on the button from the front to release
the battery pack.
Button
V.
OPERATION
[Main Body]
Switch and Forward/Reverse
Lever Operation
Forward
- 6 -
Reverse
Switch lock