Mortising Chains; Storage; Troubleshooting; Exploded Drawing And Spare Parts List - Mafell SKS 130 Traduction De La Notice D'emploi Originale

MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Mortising chains

The mortising chain used on the machine should be
cleaned and lubricated in a low viscosity oil bath after
7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine stops while mortising is in
process
Chip ejection blocked
8

Exploded drawing and spare parts list

The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
Mains failure
Machine overloaded
Unfavourable residue mortising
(see Fig. 6)
Wood is too damp
Extended mortising without
exhaustion
-21-
two hours of operation. To do so, dismantle the
mortising chain (see chapter 4.3).
Replace the blunt mortising chains or have them
reground at a MAFELL customer service station or by
a suitable sharpening service.

6.2 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
Elimination
Check power supply
Replace fuse
Take the machine to a MAFELL
customer service shop
Check mains back-up fuses
Reduce feed speed
Relocate the machine and mortise
the residue with a chain
Connect to an external extraction,
e.g. portable dust extractor