Setting / Adjustment; Mains Connection; Chip Extraction; Mortising Chain Change And Chain Wheel Change - Mafell SKS 130 Traduction De La Notice D'emploi Originale

Instructions on operation:
- Provide for an unobstructed and slip-proof location
with sufficient lighting.
- Do not work on workpieces which are too small or
too large for the capability of the machine.
- Clamp mortising
appropriately and keep in order. Repair defective
mortising chains professionally before reuse. Only
use sharp mortising chains!
- Only remove chain guard for tool change
purposes, immediately screw back on again
afterwards. Never work without chain guard!
- Never transport the chain mortiser with running
mortising chains! Avoid touching the ground with
the running mortising chain.
- The switch may not be wedged.
- Before switching on, check whether the mortising
chains are properly tensioned.
- Whenever possible secure the workpiece from
pivoting or sliding away, overturning and luffing up,
e.g by means of clamps.
- Only begin mortising the workpiece when the
mortising chains have reached their full speed.
- Examine the workpiece for foreign objects. Never
attempt to mortise into metal objects, such as
nails.
- Hold on tightly to the machine, already before
turning it on. The mortising chains must stand
unrestricted. Apply the machine for the mortising
operation with running mortising chains. Pay
attention to a secure footing.
- Never reach below or laterally onto the workpiece
during mortising (Risk of injury!).
- Always lead the connecting cable away from the
machine to the rear while mortising.
- Match the feed speed during mortising to the
material thickness. Mortising too quickly leads to
motor overload, to unclean mortises and to the
mortising chains blunting quickly.
- Only remove the machine from the workpiece if the
mortising chains have come to a standstill.
- Do not reach into the chip ejector and the
unprotected area of the mortising chain while the
machine is running.
- The wood dust arising during mortising impairs the
necessary view and is partly injurious to health. If
chains and guide
the machine is used for longer periods, it must
therefore be connected to a chip extractor, e.g. a
portable small extractor, if the work is not carried
out outdoors or in a sufficiently ventilated room.
The air velocity must be at least 20 m/s (65.6
ft/sec.).
rails
Instructions on service and maintenance:
- Regularly cleaning the machine, especially the
adjusting devices and guides, constitutes an
important safety factor.
- Only original MAFELL spare parts and accessories
may be used. Otherwise the manufacturer will not
accept any warranty claims and cannot be held
liable.
4

Setting / Adjustment

4.1 Mains connection

Prior to commissioning make sure that the mains
voltage complies with the operating voltage stated on
the machine's rating plate.

4.2 Chip extraction

Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20
m/s (65.6 ft / sec.).
The inside diameter of hose connector 7 (Fig. 2) is 35
mm (1 3/8 in.).
4.3 Mortising chain change and chain wheel
change
Pay attention that the mortising chains to be clamped
have been well sharpened as this is a basic
requirement for correct mortising.
Proceed as follows for exchanging the mortising
chain:

Clamp the machine vertically onto a piece of
wood so that the machine cannot overturn.

Unfasten the screw 9 (Fig. 2) and remove the
chain guard 8.

Slacken the mortising chains 4 (Fig. 1) by
unfastening the two screws 3.
-18-
Danger
Pull the power plug during all
service work.