Samson CONCERT 88 Manuel De L'utilisateur page 18

Quick Start - Multiple System Setup
Position the transmitter about 6-12" (15-30 cm) from the front of the CR88 with the
transmitter's IR window facing the receiver's IR transmitter.
3. Plug in receiver
9. Press and hold SELECT button to IR set
When the transmission is complete, and the CR88 is
receiving RF signal from the transmitter, the READY
9. Press and hold Select button to IR set
indicator will light on the front panel of the CR88
receiver.
If you find the system has noticeable dropouts, reduced overall working range, or
unexpected noise bursts, change the operating channel of the system using the steps
above.
18
3. Plug in receiver
Press and hold the CR88 SELECT button to synch
the transmitter to the same channel as the receiver
via infrared transmission.
FREQ:
542-566MHz
5. Plug receiver into audio system
4. Turn on receiver
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
10. Adjust Volume control
4. Turn on receiver
6. Press Select button to change ch
5. Pl