Twin-Star International Classic Flame 23DE9047 Manuel D'instruction page 8

10. Locate Mantel/Top (G) and lay f nished side
up on top of completed assembly. From the
inside, attach the Mantel/Top (G) using Bolt
(AA) through the pre-drilled holes in the
Plastic Connector (BB).
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all
Bolts alternating top and bottom, left and
right.
11. Locate Right Front Door (X) and Left Front
Door (J). Slide door hinge keyhole into panel
hinge bracket. (Diagram 1)
Use Phillips Head Screwdriver to tighten
screws.(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change
keyhole slot position.
(As Shown In Diagram 3a)
To adjust door right or left loosen / tighten
screw. (As Shown In Diagram 3b)
To adjust door up or down adjust bracket
height.(As Shown In Diagram 3c)
12. Attach the Knob (V) to the Left Front Door
(J) , Right Front Door (X) and center front
door , use the bolts attached through the
pre-drilled holes in the doors. Then use a
Phillips Head Screwdriver to tighten the bolts.
E-7
Mantel/Top
G
J
Left
Front
Door
V
Knob
X
Right
Front
Door