Connecting To A Dvd Player Via Hdmi; Connecting To A Dvd Player; Remote Control Handset; Inserting Batteries - TECHWOOD TKR 26 B 62 N Mode D'emploi

Connecting to a DVD Player

via HDMI
Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
• If your DVD player has an
connect via HDMI for better video and audio quality.
• When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player
If you want to connect a DVD player to your TV, you
can use the connectors of the TV set. DVD players
may have different connectors. Please refer to your
DVD player's instruction book for additional information.
Power off both the TV and the device before making
any connections.
Note: Cables shown in the illustration are not
supplied.
• If your DVD player has an
connect via HDMI. When you connect to a DVD player
as illustrated below, switch to the HDMI source. See
"Input Selection" section.
• Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
• You may also connect through the SCART sockets.
Use a SCART cable as shown below.
02_MB62_[GB]_(01-TV)_1910UK_DVB T_PVR_BRONZE19_(woypbpr)_26906W_10079453_50220714.indd 50 02_MB62_[GB]_(01-TV)_1910UK_DVB T_PVR_BRONZE19_(woypbpr)_26906W_10079453_50220714.indd 50

Inserting Batteries

•
•
HDMI socket, you can
HDMI Cable
(not supplied)
External device
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

To Switch the TV On

•
•
•
HDMI socket, you can
•
Note: If you switch on your TV via CH
the programme that you were watching last will be
reselected.
By either method the TV will switch on.

To Switch the TV Off

•
•
Note: When the TV is switched to standby mode,
standby LCD can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 50 -

Remote Control Handset

Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.

Switching On/Off

Connect the power cord to the 220-240V AC 50 Hz.
Then the standby LCD lights up (The led will blink
during the standby On/Off).
To switch on the TV from standby mode either:
Press the " " button, CH
button on the remote control.
Press the " " button, P/CH- or P/CH+ button on
the TV. The TV will then switch on.
buttons on the remote control or on the TV set,
Press the " " button on the remote control or hold
the " " button on the TV until shut down , so the
TV will switch to standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
or CH or a numeric
or CH
25.04.2012 15:29:08 25.04.2012 15:29:08