Storage And Disposal; Other Functions - SOLAC SW8221 Mode D'emploi

- Hints: our sewing will be neater if you guide the fabric as it passes
through the machine.
- CAUTION: Stop the sewing machine and raise the needle and the
thread tension lever to their highest positions when you rotate the
pattern selection dial. Turning the dial while the machine is running
can damage the machine.
10. When you have finished sewing, pull the fabric slightly and cut the
thread.
11. To keep the thread from unravelling, pull out the upper thread from
the rear of the fabric and tie it off with the bobbin thread.

OTHER FUNCTIONS

Overlocked
- To finish off the edges of any fabric, start sewing 0.3cm from the edge.
- We must select an overlock or overlock stitch, leaving the width and
length values that come by default. (depending on the machine they
will be one or the other)
- Advancing slowly, the fabric that we have left, while the needle is
making the overlock or overlock stitch to obtain a perfect finish on the
piece. When the end of the fabric is reached, we finish off.
Pre-riveted drilling
- It consists of moving the needle without thread front and back to pier-
ce the fabric and thus be able to put a brooch or a rivet.
- If you want a bigger hole you should change the needle to a thicker
one.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off:
- If you are using batteies, put the knob to "FOOT pedal position"
- If you are connected to the main. Put the knob to FOOT pedal
position and unplug from the mains,
- Clean the appliance.
- Remove the batteries from the appliance.
CLEANING
- Disconnect the appliance from the mains and allow it to cool before
undertaking any cleaning task.
- If appliance has assembled baterries remove them to before cleaning.
- Clean the equipment with a damp cloth with a few drops of wash-
ing-up liquid and then dry.
- Do not use solvents, or products with an acid or base pH such as
bleach, or abrasive products, for cleaning the appliance.
- Do not let water or any other liquid get into the air vents to avoid dam-
age to the inner parts of the appliance.
- Never submerge the appliance in water or any other liquid or place it
under running water.

STORAGE AND DISPOSAL

- Store this product in a dry and safe location, and no keep it in any of
the following locations:
1. Locations tat are subjected to extrem heat or cold.
2. Dusty or wet locations.
3. Near heat sources or fire.
4. Outdoors or direct sunlight.
5. Oily, smoky or steamy locations
6. Within reach of children or near pets.
- When storing the product, keep it away from grease, oil, mud, snow,
wet paint, and slippery objects.
- When storing the product, keep it cleanand keep it away from hazard-
ous substances.
- Store the product in falt and safe location.
- Remove the batteries.