SOLAC SW8221 Mode D'emploi page 15

6. Rotate the hand wheel to raise the needle to its highest position and
pass the thread through the eye of the needle from the front to the back.
Use of the needle threader
1. Pass the tip of the needle threader through the eye of the needle from
the rear of the machine to the front.
2. Pass the thread through the ring.
3. Gently pull on the needle threader to pass the thread through the eye
of the needle from the front toward therear.
THREAD THEBOBBINTHREAD
- Thread the upper thread before threading the bobbin thread. You will
not be able to bring up the bobbin thread unless you have already
threaded the upper thread.
- CAUTION: Be sure to use metalbobbins.
1. Rotate the hand wheel toward you (counter clockwise) to raise the
needle to its highest position. Lift the presser foot lifter.
2. Push the hook cover plate release button to remove it.
3. Pull out about 10 cm of thread from the bobbin and insert the bobbin
so it winds to the right.
4. Hold the end of the upper thread and rotate the hand wheel toward
you (counter clockwise) while gently pulling on the upper thread until the
bobbin thread emerges from the bobbin thread hole.
5. Pull the bobbin thread when it emerges from the bobbin thread hole.
It's easier to pull the thread out if you use a rod with a small tip.
6. Pass the upper and bobbin threads to the rear under the presser foot,
pulling them out together about 10 cm.
7. Attach the hook cover plate.
- Note: The upper and bobbin thread must be correctly installed. Sew
a test piece to make sure the machine is sewing correctly and then
begin sewing your project.
WINDING THREAD ONTO THE BOBBIN
- This is how you wind thread onto an empty bobbin (Make sure the
needle threadis not being threaded).
- CAUTION: Be sure to use metalbobbins.
1. Place a spool of sewing machine thread onto the thread spindle and
place the thread cap or place the thread spool on the desk (If the thread
spool is big).