Storage And Disposal - SOLAC SW8220 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Lower presser foot lifter and make sure the needle is in its high
position.
6. Select Pattern selection dial to "
stitches.
7. Select Pattern selection dial to "
8. Select Pattern selection dial to "
stitches.
9. Select Pattern selection dial to "
needle reaches the stitches sew in step 6.
- Hints: our sewing will be neater if you guide the fabric as it passes
through the machine.
- CAUTION: Stop the sewing machine and raise the needle and the
thread tension lever to their highest positions when you rotate the
pattern selection dial. Turning the dial while the machine is running
can damage the machine.
10. When you have finished sewing, pull the fabric slightly and cut the
thread.
11. To keep the thread from unravelling, pull out the upper thread from
the rear of the fabric and tie it off with the bobbin thread.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off:
- If you are using batteies, put the knob to "FOOT pedal position"
- If you are connected to the main. Put the knob to FOOT pedal
position and unplug from the mains,
- Clean the appliance.
- Remove the batteries from the appliance.
CLEANING
- Disconnect the appliance from the mains and allow it to cool before
undertaking any cleaning task.
- If appliance has assembled baterries remove them to before cleaning.
- Clean the equipment with a damp cloth with a few drops of wash-
ing-up liquid and then dry.
- Do not use solvents, or products with an acid or base pH such as
bleach, or abrasive products, for cleaning the appliance.
- Do not let water or any other liquid get into the air vents to avoid dam-
age to the inner parts of the appliance.
- Never submerge the appliance in water or any other liquid or place it
under running water.
" to sew back bar tack for 4 or 5
" to sew right side bar tack.
" to sew front bar tack for 4 or 5
" to sew left side bar tack until the

STORAGE AND DISPOSAL

- Store this product in a dry and safe location, and no keep it in any of
the following locations:
1. Locations tat are subjected to extrem heat or cold.
2. Dusty or wet locations.
3. Near heat sources or fire.
4. Outdoors or direct sunlight.
5. Oily, smoky or steamy locations
6. Within reach of children or near pets.
- When storing the product, keep it away from grease, oil, mud, snow,
wet paint, and slippery objects.
- When storing the product, keep it cleanand keep it away from hazard-
ous substances.
- Store the product in falt and safe location.
- Remove the batteries.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical support service if prod-
uct is damaged or other problems arise. Do not attempt to disassem-
ble or repair the appliance yourself as this may be dangerous.
For EU product versions and/or in case that it is requested in your
country:
ECOLOGY AND RECYCLABILITY OF THE PRODUCT
- The materials of which the packaging of this appliance consists are
included in a collection, classification and recycling system. Should
you wish to dispose of them, use the appropriate public recycling bins
for each type of material.
- The product does not contain concentrations of substances that could
be considered harmful to the environment.
This symbol means that in case you wish to dispose of the
product once its working life has ended, take it to an authorised
waste agent for the selective collection of Waste from Electric
and Electronic Equipment (WEEE).
This appliance complies with Directive 2014/35/EU on Low Voltage, Di-
rective 2014/30/EU on Electromagnetic Compatibility, Directive 2011/65/
EU on the restrictions of the use of certain hazardous substances in
electrical and electronic equipment and Directive 2009/125/EC on the
ecodesign requirements for energy-related products.

Publicité

Table des Matières
loading

Table des Matières