SOLAC SW8221 Mode D'emploi page 19

7. Make sure that the Power / Speed switch is set to "Foot pedal posi-
tion" and the adaptor is plugged in.
8. Start sewing again while pressing the fabric gently.
- How to use the operating power/ speed switch
- FOOT Pedal position: Appliance only works with the foot pedal
- I: The machine will move slowly.
- II: The machine will move quickly.
- When using the foot pedal (one speed foot pedal):
- Make sure power / speed switch is in "FOOT PEDAL" position.
- The machine will run only while you are pressing the pedal with your
foot.
9. When you have finished sewing, rotate the hand wheel toward you
(counter clockwise) to raise the needle and the take-up lever, and raise
the presser foot lifter.
10. Remove the fabric and cut the thread with the thread cutter.
- Hints: If the thread is caught and you cannot remove the fabric, rotate
the hand wheel back and forth slightly to make it easier to remove the
thread and the fabric.
WHEN REVERSE STITCHING
- The machine will sew in reverse only while the reverse lever is pushed
down.
WHEN CHANGING SEWINGDIRECTION
1. OFF: Stop the sewing machine placing the sped knob to "Foot pedal
position"
2. Lower the needle by turning the hand wheel toward you (counter
clockwise) to insert the needle into the cloth.
3. Raise the presser foot lifter to raise the presser foot.
4. Rotate the fabric.
5. Lower the presser foot lifter to begin sewing again.