Coffee Beans; Setting The Time; Setting The Coffee Strength - Unold 28736 Manuel D'utilisation

4. Fill the water tank (5) to the MAX
marking/12 cups with tap water.
Ensure that there are no beans in
the bean container (4).
5. Close the lid of the glass pot and
place it on the warming plate (8).
6. Plug the power cord into an elec-
trical outlet (220–240 V~, 50 Hz)
7. Caution: All operating entries via
the buttons will only be saved as
long as the display is illuminated
blue. As soon as the display light
goes out, you must first press a

COFFEE BEANS

1. With the Coffeemaker Mühle, cof-
fee can be prepared from fresh
ground beans, or with off-the-
shelf coffee powder.
2. If you want to use coffee beans,
when purchasing them, ensure
that the beans are suitable for

SETTING THE TIME

1. As soon as the coffeemaker is
connected to the power supply
the display shows 12:00.
2. Now press the „STD" ("HOUR")
and "MIN" buttons until the cur-
rent time is set.
3. You will see the current time and
can start brewing coffee.

SETTING THE COFFEE STRENGTH

1. Use the „STÄRKE" ("STRENGTH")
button to select the desired cof-
fee strength. Press the „Stärke"
("STRENGTH") button until the
button before additional button
entries are possible.
8. Press the button „MÜHLE AUS"
(„MILL OFF"), then „EIN/AUS"
("ON/OFF") and let the water run
through until the appliance indi-
cates through a signal tone repea-
ted multiple times, that the pro-
cess is concluded.
9. Please discard this water.
10. Clean the glass pot.
11. Switch off the appliance via the
„EIN/AUS" ("ON/OFF") button.
coffee mills. Do not use beans
for fully-automatic coffee makers;
these beans do not produce a
satisfactory flavour of the coffee
due to the different roasting pro-
cess.
4. In case of a power outage lasting
longer than about 30 seconds the
time is not saved, which means
you must reset the time whe-
never the appliance has been
unplugged.
desired number of coffee beans is
shown in the display.
2. You can choose from the following
degrees of strength:
23