Watchguard Firebox T15 Guide De Démarrage Rapide page 3

About the Firebox Status Lights
Fail Over – Lights when there is a WAN failover from the primary external interface to the backup
interface.
WAP - (Wireless models only) Lights when the device is activated as a wireless access point or as a
wireless client.
Network interface status indicators – The Firebox T15 has five network interfaces. There are two
status indicators for each interface.
Indicator Indicator color
1000 Yellow
Blinks*
10/100 Green
Blinks*
Status – Shows when there is a management connection to the device. The Status indicator is lit for
30 seconds after you connect to the device with the Fireware Web UI or the command line interface.
It is also lit when the device is polled by WatchGuard System Manager.
Mode – Shows the status of the external network connection. If the device can connect to the
external network and send traffic, the indicator is green. The indicator flashes if the device cannot
connect to the external network and send traffic.
Attn – Lights when you start the device with the Reset button pressed.
Power (
) – The power indicator is lit when the device is on.
4
Interface Status
Link speed: 1000 Mbps
Data sent and received
Link speed: 10 Mbps or
100 Mbps
Data sent and received
* Blink speed increases as the data flow increase
s
Install Your Firebox
For instructions to install your Firebox in a network rack, see the Firebox T15 Hardware Guide.
Reset the Firebox to Factory-Default Settings
If you ever need to, you can restore your Firebox to its factory-default settings. For example, if you do
not know the administrator account passphrase or you want to start over with a new configuration,
you can reset your Firebox. Make sure you back up your Firebox configuration before you reset your
Firebox in case you want to restore it in the future.
For information about how to reset your Firebox, see the Firebox T15 Hardware Guide,
available at: www.watchguard.com/help/documentation/hardware.asp
5