REMIS REMIFLAIR IV Mode D'emploi page 11

D. Information about maintenance
D1
D2
1. Care:
2. Maintenance/repair:
3. Storage of documentation:
4. Obtaining replacement parts:
D1:
Tighten roller blind / loosen tension:
To tighten the roller blind, press the spring compressor
with a screwdriver in the frame corner and turn it clock-
wise. To release the tension, press the spring compressor
inward and turn it counterclockwise.
D2:
Tighten plissée / loosen tension:
Loose the grub screw in the cord clamp with a hexagon
socket (1.5mm). Pull the cord tighter and slide the cord
clamp to the support leg to tighten the plissé. To release
the tension, slide the string stretcher in the opposite direc-
tion. Turn tight the grub screw. Repeat the process on the
other side.
Make sure that the handle bars are parallel to the cassette
after stretching / relaxation.
Never use aggressive detergents (solvents/ab-
rasives). Frame part of the black-out system can
be cleaned with a moist cloth and mild soapy
water. The plissé as well as the insect protection
should be cleaned carefully using a soft brush or
a moist cloth.
The system does not need any maintenance.
If possible, the user information with the opera-
ting and installation instructions should be kept
inside the car in case they are needed.
You can get spare part from an authorised
dealer.
US/GB
11/32