Getting Started; Service And Warranty - Dremel Fortiflex 9100 Série Traduction De La Notice Originale

ASSEMBLY
FIGURE 1
A = Power cord
B = Foot pedal
C = Hanging motor
D = On/Off switch
E = Hanger
F = Flexible shaft
G = Hand piece
H = Wall mounting piece
I = Metal hook
J = Allan key
K = Key
GENERAL
1. Mount the inner shaft to the spindle of the motor. FIGURE 2
2. Mount the outer shaft to the motor by turning it counter-
clockwise. FIGURE 3
3. Mount the hand piece on the other end of the shaft. FIGURE 4
4. Mount the metal hook to the wall just above where you work.
5. Connect the motor to the foot pedal. Connect the foot pedal to
the outlet. FIGURE 5
Do not connect the motor to the outlet directly.
6. Hang the motor on the hook.
CHANGING ACCESSORIES
1. Check if switch is in "0" position.
2. Use key to unlock and lock accessories in the chuck. FIGURE 6

GETTING STARTED

1. On/off switch
Switch on/off the tool by pushing knob D (FIGURE 1) in
"I"/"0" position.
2. Foot speed control
Control the speed stepless with your foot by applying less or
more pressure on the pedal. FIGURE 7
HOLDING AND GUIDING THE TOOL
• Pencil grip for precision work (engraving). FIGURE 8
• Hand grip for rough work (grinding). FIGURE 9
Do not bend shaft at tight angles. FIGURE 10
APPLICATION ADVICE
• Tool is intended to be used for woodworking, jewellery
making, stone working and artisan projects.
• When used with the appropriate accessories this tool can be
applied for grinding, sanding, cutting, engraving, polishing,
drilling.
USE
• Recommended speed
low – medium
medium – high
• Always practice on a piece of scrap material first to choose
the right accessory and determine the optimum working
speed.
• Do not apply too much pressure on the tool; let the speed
do the work for you.
MAINTENANCE
• Flexible shaft needs to be lubricated regularly:
– switch off tool and remove plug from power source.
– remove hand piece.
– remove outer shaft by turning it clockwise. FIGURE 3
– lubricate inner shaft with lubrication grease. Do not use
too much grease.
– mount outer shaft by turning it counter-clockwise.
– mount hand piece.
• Excessive sparking mostly indicates worn-out carbon brushes.
CLEANING THE TOOL
DISCONNECT THE PLUG BEFORE CLEANING
• Keep tool and cord clean (some household cleaning products
and solvents can damage plastic parts; these products include
among others benzene, trichloroethylene, chloride, ammonium).
Ventilation openings and switch levers must be kept clean and
free of foreign matter. Do not attempt to clean by inserting
pointed objects through openings.
The tool may be cleaned with compressed air. Always wear safety
goggles when cleaning tool with compressed air.

SERVICE AND WARRANTY

This DREMEL product is guaranteed in accordance with
statutory/country-specific regulations; damage due to normal
wear and tear, overload or improper handling will be excluded
from the guarantee.
In case of a complaint, send the tool undismantled together with
proof of purchase to your dealer.
CONTACT DREMEL
For more information on the Dremel assortment, support and
hotline, go to www.dremel.com
Dremel Europe, P.O. Box 3267, 4800 DG Breda, The Netherlands
11
precise drilling, polishing
sanding, cutting, engraving