Vortice QE-B I/M Notice D'emploi Et D'entretien page 54

ENGLIsH
QE-MH
Kit for recessed installation of plasterboard structures (fig. 1÷5)
Required:
1 mounting support (fig.2, A)
2 hex head screws (fig.1, A))
2 hexagonal nuts (fig.2, B)
Fixing to the plasterboard structure is carried out by means of a kit with wall supports (pos.A fig. 4).
The bracket can be shortened near the notch. (fig.2, C)
QE-TEK
Kit for secondary extraction from toilets (fig. 6÷8)
Keep in mind regulations of the countries of installation when installing toilets. Installation without filters is not
recommended as the appliance and the entire duct would dirty.
Pre-cut opening for discharge pipe connection (right or left) (fig.6, A)
QE-uMB
universal bracket for recessed installation (fig. 9÷14)
Additional adjustment
Align the installation position to the current situation, loosening the side screws in the bracket slots in height
and depth. Firmly tighten the screws.
Required:
1 wall bracket (fig.12, A)
2 side bars (fig.11, A)
1 mounting bracket (fig.10, A)
2 Mx16 hex head screws (fig.9, A)
2 M6 hexagonal nuts (fig.10 B)
4 M6x10 self-tapping screws (fig.11, B; fig.12, B)
The bracket can be shortened near the notch (fig.10, C)
Wall mounting: fig.13. (A: Align perpendicularly)
Measurements can be modified: space between the wall and the rear side of the box: fig. 14 (A: long, B: short,
C: short rotatable)
QE-Ad
Vent for second room connection (fig.15÷16)
Pre-cut opening for discharge pipe connection (right or left): (fig.15, A).
Discharge upward. Connection for right or left second room discharge: (fig.15, B).
Connection vent for second room discharge QE-AD: (fig.15, C).
QE-fBA
Adapter for recessed box installation (fig.17÷20)
Adapter for plasterboard, to be used to insert recessed boxes on toilet walls at the front. This accessory is
composed of an adapter and 4 screws.
Fig.18: connect the cable to the terminals on the box. Connect and seal the flexible hose with the discharge
vents. Do not bend the hose.
Fig.20: install perpendicularly. IMPORTANT: the box should not in any case be deformed.
Screws not supplied.
55