2. Remove bolt µ and hinge-C ¸ and take off
refrigerator door ¹.
Move cap
to the side not used.
Move door bracket
and screw
side you wish and reinstall.
15
3. Move hinge-U pin
and top cover cap
Assemble the refrigerator door ¹.
Assemble hinge-C ¸ and bolt µ.
Assemble freezer door
.
21
Assemble the hinge-L ´ and bolt ¿.
Assemble base cover ³ and screw ·.
10
11
5
4
1
After Completing the job
Make sure that the four corners of the door
gasket are not folded. It is recommended to
to the
apply a small amount of silicon grease on
them.
Adjust the leveling screw on the bottom to
the highest level so that the front side of the
refrigerator is higher than the rear side.
14
If you need assistance after switching the
direction of the door opening as shown
above, call a service center.
Reversing the doors is not covered by the
warranty.
12
.
21
2
NOTE
13