Christopeit Sport BT 6 Notice De Montage Et D'utilisation page 18

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts have been connected directly to
the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will
make it easier and quicker for you to assemble the equipment.
Step 1:
Attach the stabilizer (57+93) at main frame (33).
1. Attach the front foot (57) with the preassembled transport rollers (55)
to the main frame (33). Do this with the two screws (56), washers (13),
spring washers (22) and cap nuts (59).
2. Attach the rear foot (93) to the main frame (33). Do this with the two
screws (56), washers (13) spring washers (22) and cap nuts (59).
After assembly has been completed, you can compensate for minor
irregularities in the floor by turning the cap (94). The equipment should
be set up that the equipment does not move of its own accord during
a training session.
Step 2:
Assembling of the connection cable (2) with the motor cable (32) and
installation of the support (4) at main frame (33).
1. Place screws (31), washers (13) and spring washers (22) accessibly
beside the front part of the main frame (33).
2. Place the lower end of the support (4) against the main frame (33) and
plug the ends of connection cable (2) and motor cable (32) projecting
from (4) and (33) together.
(Note: The computer cable harness (2) projecting from the support (4)
must not slide into the tube, as it is required for later steps of installation.)
When joining the tubes, ensure that the cable connection is not trapped.
3. Put one spring washer (22) and one washer (13) on each screw (31).
Push the screws (31) through the holes in the support (4), screw into the
threaded holes of the main frame (33) and tighten lightly. (This screw
connection point will screw firmly at least in Step 4)
18