Philips Sonicare FlexCare Platinum Mode D'emploi page 13

Pressure Sensor
A change in vibration (and a slight change in sound)
alerts you when you apply too much pressure while
brushing. See chapter 'Features'.
Battery status (when handle is not on charger)
- 1 yellow LED indicates a low charge.
- 3 green LEDs indicate a full charge.
Note: If you hear a long beep and the yellow LED of
the battery level indicator flashes, the rechargeable
battery is empty and the Sonicare switches off.
Place the handle on the charger to recharge it.
Note: To keep the battery fully charged at all times,
you can keep the Sonicare on the charger when you
are not using it.
Features
Pressure Sensor
This Sonicare comes with the Pressure Sensor feature
activated. The Pressure Sensor works in all 3 modes
and at all 3 intensity levels. To deactivate or reactivate
the Pressure Sensor feature:
1 Place the handle with a brush head attached on
the plugged-in charger or sanitiser.
2 Press and hold the power button and the
mode button for 2 seconds.
, You hear 1 beep to indicate that the Pressure
Sensor has been deactivated.
, You hear 2 beeps to indicate that the Pressure
Sensor has been activated.
EngliSh
13