Earth Connection; Possible Faults; Important - ELEPHANT A15 Instructions De Montage

UK
Installation of ELEPHANT Energizer
Before you start the installation of the controller
it is important that the instructions are studied
carefully. A correct installation is essential if you
want an optimal functionality of your Energizer.

Earth Connection

In order that your electric fence generates the
best possible shock, it is important that the
connection to earth is perfect. An earth rod is
usually 2 m long and produced in 20-25 mm
galvanised iron pipe. It is recommended that
the earth rod be inserted at least 1.5 m into
the earth. The connection from the energizers
earth clamp to the earth rod can be a piece of
galvanised fence wire. You can also use a high-
voltage cable. Never use a standard electrical
cable. Secure the connection to the earth rod
with a stainless collar band or a stainless/
galvanised steel bolt.
See also "Testing your fence/earth
connection".
The connection to the fence
If the Energizer is placed a long distance from
the fence, the use of high-voltage cable is
recommended to connect the fencing clip on
the controller to the wire connection.
Especially in tunnels or alongside buildings
high-voltage insulated fencing cable must be
used. Normal electric wire must never be used.
Testing your fence/earth connection
At least a 100 mtrs away from the earthing
system, measure with a digital voltmeter
(art. nr.:4002227) if the current is more than
3000 V. Create a short circuit by putting iron
posts against the fence-wire. If the current
measured on the earthing system is more than
300V more earthing rods need to be placed
(distance 3 mtrs). Repeat the test.

Possible faults

• Poor earth connection
See how to create a perfect earth connection
"Testing your fence/earth connection"
under
• Poor wire joints
Poor insulators, especially on iron poles.
Spark flashover on a fence pole can often be
heard clearly.
If the connection to earth, wire joints and
insulators is in working order, you can assume
that the fence is generating an even current all
around the enclosure.
4
700034014_A15, A30, A45_A5.indd 4
Guarantee
If your electric fence is not working properly,
you must dismantle it and return it to where
you bought it. Remember to bring your receipt.
Electric fences that are less than 3 years old
are repaired free of charge, on the condition
that the damage has not been caused by
unauthorised intervention or by the device
having been connected to an incorrect voltage.
The guarantee does not cover misuse, neglect
or lightening damage. There is no guarantee or
compensation for indirect damage.
Installation of Solar system on A15, A30,
A45
The ELEPHANT SOLAR system consists of a
Solar Module, 2 angle clamps (45 degrees) and a
protection box.
Disconnect the connection to the fence wire.
Assemble the protection box and the 2 angle
clamps (left+right) upon.
Connect the 12V cable to the wet battery.
(Red = + )
Connect the cable from the solar module to the wet
battery. (Red = + )
The solar module should be facing south.
Establish the connection to the fence wire.
Turn the ON/OFF switch ON and the system will
start working. The system will work steadily from
March to October. During the season's extremes
(beginning/end) it is wise to keep an eye on the
indicator. If the time gap between flashes is
more than 3 seconds, light intensity is no longer
sufficient.

Important!

During periods when the appliance is not in
use, it is important the battery is kept charged.
Therefore, place the appliance there where the
solar cell can occupy the most daylight.
.
The power switch must be in the disconnected
position
See also www.elephant.as
02-11-15 12:05