Sony VGP-UHDM25 Mode D'emploi page 4

Sony hereby, declares that this product is in
compliance with the essential requirements and other
relevant provisions of European Directive 1999/5/EC.
To obtain a copy of the declaration of conformity (DoC)
with the R&TTE Directive, please access the following
URL address:
http://www.compliance.sony.de/
This equipment also complies with EN 55022 Class B
and EN 55024 for use in following areas: residential,
commercial and light industrial.
This equipment has been tested and found to
compliant with the limits set out in the EMC
Directive for using connection cable not longer than 3
meters (9.8 Feet).
The supplied interface cable must be used with the
equipment in order to comply with the limits for a
digital device pursuant to EN 55022.
Emissions from this inductive device could cause
interference to nearby receivers of other radio services.
GB
4
Be careful not to lose the wireless
keys
Be careful not to lose the wireless key registered to the
hard disk drive. If you lose both of the wireless keys,
the hard disk drive cannot be recognized by your
personal computer. See "If you lose a wireless key/If
the wireless key is broken" (page 24).
Make sure to backup the data with
some other media
Make sure to backup the data of the hard disk drive. If
the data cannot be restored as a result of hard disk
trouble, Sony will not accept any liability whatsoever.
On battery replacement
Replace all the batteries soon if the BATT indicator
flashes. A malfunction may occur if you keep using
the weak batteries. Alkaline batteries are
recommended.
When disconnecting the hard disk
drive
Do not disconnect this unit from the personal
computer too forcefully. This may cause a
malfunction.
Make sure to follow the procedure described in
"Disconnecting the drive from the personal
computer."
VGP-UHDM25_4-107-783-11 (1)