Before Starting The Equipment; Important; Operation; Cleaning, Maintenance And Ordering Spare Parts - EINHELL TE-VC 18 Li Traduction Du Mode D'emploi D'origine

5. Before starting the equipment

Warning!
Always remove the battery pack before making
adjustments to the equipment.
5.1 Assembling the equipment
Fitting the nozzles (Fig. 1-2)
The nozzles (5, 6, 7) can be fi tted to the vacuum
cleaner either directly on the intake opening (10)
or via the extension tube (8).
Fitting/removing the fi lter (Fig. 1-4)
Press the locking switch (4) and remove the
tank at the same time (3). You can then take the
fi lter (9) out of the tank (3) (Fig. 3). The fi lter (9)
must be completely taken apart to enable it to be
thoroughly cleaned (Fig. 4).
After cleaning, fi t the fi lter (9) back in the tank (3)
(Fig. 3). Then fi t the tank (3) back on the vacuum
cleaner (Fig. 5).
Fitting the wall holder (Fig. 7)
Fit the wall holder (11) as shown in Fig. 8.
Suitable fastening materials such as screws
(Ø 5⁄32 in. (4 mm)), etc., are available from your
dealer. The holder provides a practical means of
storing the handheld vacuum cleaner after use
(Fig. 9)

Important!

The wall holder is only suitable for use with
Einhell cordless handheld vacuum cleaners. It is
not suitable for bigger loads!
5.2 Suction nozzles
Combination nozzle (Fig. 2)
The combination nozzle (7) is for vacuuming
solids over medium to large areas.
Crevice nozzle (Fig. 2)
The crevice nozzle (6) is designed for vacuuming
solids in corners, edges and other areas that are
diffi cult to access.
Upholstery nozzle (Fig. 2)
The upholstery nozzle (5) is specially designed
for vacuuming solids on upholstery and carpets.
Anl_TE_VC_18_Li_USA_SPK7.indb 9 Anl_TE_VC_18_Li_USA_SPK7.indb 9
EN

6. Operation

On/Off switch (Fig. 1/Item 1)
Switch position OFF: Off
Switch position ON: On
6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator (Fig. 6 / item
13)
Press the battery capacity indicator switch (12).
The battery capacity indicator (13) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend cleaning the equipment
immediately each time after use.
7.2 Cleaning the tank (3)
The tank can be cleaned with a damp cloth
and some soft soap or under running water,
depending on the amount of dirt.
7.3 Cleaning the fi lter (9)
Clean the fi lter (9) under running water and allow
it to air-dry.
- 9 -
06.06.2019 08:57:30 06.06.2019 08:57:30