Step 5 Attaching The Feet - Werner AH2210 Série Instructions D'installation

Step 5 ATTACHING THE FEET

INCLUDED COMPONENTS & FASTENERS
(1) Left Foot
Assembly
(1) Right Foot
Assembly
At the completion of Step 5 the hinges in your ladder should have
no gaps as shown in the Correct Setup
No Gap
Feet are flush with
floor
Correct Setup
The bottom section must fit flush with the floor. Failure to properly adjust the feet on the ladder could result in
unnecessary stress on the component parts, resulting in serious injury.
10
(2) 1/4"-20 Hex Head
Cap Screws
3/4" Long
Gap
No Gap
Feet are not
flush with floor
(2) 1/4"-20
Lock Nut
Lower Section is
Too Long
WARNING
TOOLS
NEEDED
Hacksaw
Tape Measure
Pencil
Drill
9/32" Drill Bit
Carpenter's Square
Wrench, 7/16" (2)
Feet are
not flush
with floor
Lower Section is
Too Short
Gap