Basic Settings - easydriver safetyre Instructions D'utilisation

7.1 Setting up the sensors
To set up a sensor, briefl y tap the display of the sensor.
Each sensor has an ID, which consists of 5 characters.
You can enter the ID manually using the keyboard or use
the camera to read the QR code on the sensor:
GB5

7.2 Basic settings

You can access the settings via the button with 3 dots in
the upper left corner.
Here you can defi ne the units for pressure and tempe-
rature.
Use the sliders to set the warning limits for the tyre pres-
sure. For vehicles with two axles, you can defi ne diff erent
values for front and rear axle.
The app receives data even when running in the back-
ground. Under „Notify" you defi ne whether the app dis-
plays a message when a limit is exceeded.
Note: The temperature-warning limit is fi xed at 100°C
and cannot be changed.