Factory Reset; Unpacking And Installation; For Your Safety - Gear4 HouseParty PG732EUK Notice D'utilisation

5 seconds of no activity.

Factory reset:

■ To restore the speaker to factory reset
remove the power source and backup battery
for 10 seconds.
Note: Any settings you have saved in the
following functions will be deleted after a
factory reset: Time; Alarms.
Register your HouseParty Rise Wireless to
activate your warranty and receive product
updates at www.gear4.com/register
Please ensure that your device is using the
latest software version.
Copyright © 2012 Disruptive Limited. All rights
reserved. Reproduction in part or in whole is
prohibited. GEAR4 and HouseParty are trade
marks of Disruptive Limited.
WARNING
To reduce the risk of fire or electric shock, do
not expose this unit to rain or moisture.
The apparatus shall not be exposed to dripping
or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
CAUTION
Use of controls or adjustments of performance
or procedures other than those specified may
result in hazardous radiation exposure.
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
sunshine, fire or the like.
Ensure batteries are inserted as indicated inside
the battery compartment.

UNPACKING AND INSTALLATION

Unpack your unit carefully. We recommend that
you save the packaging in case you ever need
to store your unit. To avoid damage, never place
the unit or its batteries near radiators, in front of
heating vents, under direct sunlight or near water.

FOR YOUR SAFETY

‒ When disconnecting the power supply, pull
the plug first. Do not pull the cord by itself.
‒ Never handle the power plug with wet hands,
as this could cause fire or electric shock.
‒ Refer servicing to qualified personnel only.
‒ Do not open the housing.
‒ Do not twist or pinch the power supply cord.
If the plug or power supply cord needs to be
replaced, ensure that it complies with the
manufacturer's recommendation.
‒ Unplug the unit during lightning storms and
when unused for extended periods of time.
‒ Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
User Manual | HouseParty Rise Wireless | GEAR4 5