Witter F151U Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 2 Side Arm
C 2 Cage Nut Retainer
D 4 M10 x 40 x 1.5 Bolts, Lock Washers, Plain Washers, M10 Witter Cage Nuts & Retainers
E 4 M12 x 35 x 1.75 Bolts, and Serrated Flange Nuts
ZE 1 Electrical Plate (Z99) and Electrical Plate Bracket (ZEQ4)
ZN 1 3008 Series Neck Kit
FITTING
Remove bumper (2 wheel arch liner screws and 1 nut behind wheel arch liners each side. 2 fixings on top edge of
1
bumper and 2 fixings on lower face of bumper).
Remove bumper beam.
2
Pre-Assemble Witter Cage Nuts (D) to their Retainers (C)
3
Insert Cage Nut Retainers (C) into chassis rails.
4
Loosely attach Side Arms (B) to outside face of each chassis rail using remaining bolts (D) into the Witter Cage Nuts in
5
Retainers (C)
6 Loosely attach Cross Bar (A) to Side Arms (B) using fasteners (D).
Replace bumper beam and bumper.
7
Attach the chosen Neck Kit (ZN) Electrical Plate Bracket & Electrical Plate (ZE) as per separate instructions.
8
9 Fully Tighten all bolts.
Note: This tow bar must be used with a Witter '3008 Series' Tow ball / Neck Kit or Class A50-1 or A50-X tow ball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the tow bar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings:
Grade 8.8: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
Grade 10.9: M12 – 139Nm.
W0001F151U-FIT$011106220000kÄ
W0001F151U-FIT$011106220000
TOWBAR
For FORD FOCUS 4 ESTATE
F151U
For use with
2011 -
3008 series
necks