Filter Reset
05 Water/Ice / Dispenser Lock (3 sec)
Water/Ice
Dispenser Lock
(Dispenser panel /
Dispenser lever)
06 Network connection
You can control and monitor your refrigerator on the SmartThings app. For more
information, see the SmartThings section.
FDR_AW2-FS_DA68-03873A-00_EN.indd 45
After about 6 months (and typically, about 300 gallons
(1200 L) of water), the Filter indicator blinks red for several
seconds when you open the door, reminding you that the
filter needs to be replaced.
When this happens, replace the filter, and then press and hold
Ice Maker for 3 seconds. The filter lifecycle will be reset and
the Filter indicator turns off.
NOTE
• Some regions have relatively large amounts of lime in
their water. This can reduce the lifecycle of the filter. In
these areas, you will have to replace the water filter more
often than specified above.
• If water is not dispensing properly, the water filter is most
likely clogged. Replace the water filter.
You can dispense chilled water, cubed ice, or crushed ice. To
dispense, press Water/Ice. The corresponding indicator turns on.
To prevent use of the dispenser panel buttons and the dispenser
lever, press and hold Water/Ice for more than 3 seconds.
If you press and hold the button again for more than 3 seconds,
the dispenser lock will be deactivated.
NOTE
• The Dispenser Lock on the dispenser panel does not affect the
controls on the main panel. To lock the main panel, use the
Control Lock function on the main panel.
• If you press Water/Ice for 3 seconds when both control lock
and dispenser lock are active, you will deactivate both control
lock and dispenser lock.
English 45
2019-05-17
10:23:31