Gas Regulator Installation - Summit SBC635MWKD Mode D'emploi

WINE KEG DISPENSER ASSEMBLY, continued
Use a gas mixture consisting of 75% nitrogen (N

Gas Regulator Installation

Proper installation of your gas
regulator and a thorough
understanding of gas canisters are
essential to the safe use of this
product. Review and follow
instructions for handling gas cylinders
and this section in particular to ensure
your safety and the safety of others.
NEVER CONNECT A GAS
CANISTER DIRECTLY TO THE
UNIT! To avoid potential explosion
that could result in grave injury or
even death, ALWAYS CONNECT
THE CANISTER TO THE GAS
REGULATOR.
IMPORTANT! The gas canister is
shipped to you EMPTY for safety
reasons. You will need to get this
canister filled before you can use your unit. In most areas, you can get canisters filled at:
 stores that sell kegs
 party stores or convenience stores
 fire and welding supply stores.
DO NOT ATTEMPT TO REFILL GAS CANISTERS YOURSELF!
DANGER! Any pressurized gas is potentially dangerous. Canisters or cylinders are under
pressure and proper handling is essential to safety. ALWAYS HANDLE WITH CARE!
To install the dual-gauge regulator:
1. Insert the end of the gas line with the green coupler onto the bottom end
of the regulator. (See Figure D above and Photo 1, next page.) Secure
line to regulator by tightening the green coupler.
2. Next, insert the black rubber washer that comes with this unit into the
attachment nut on the regulator (as shown in figure E).
3. Connect the regulator to the canister by screwing the attachment nut
onto the canister valve (see Figure F). Tighten with an adjustable
wrench (not provided), but DO NOT OVERTIGHTEN.
4. Secure the canister with the rubber restraining strap (on side of wine
keg dispenser cabinet) as shown in Figure D. Be sure to situate the
canister so that the gauges are easily readable and the shut-off valves
are easily accessible.
See following page for examples of correct connections.
SPECIAL PRECAUTIONS: Ensure that the safety devices for your
pressurized system are installed and remain installed. Once installed,
NEVER remove the rubber washers in the regulator attachment nut to the
canister or in the tap mechanism. NEVER bypass these safety features.
Failure to comply will void your warranty and could result in serious injury or death!
) and 25% carbon dioxide (CO
2
Gas Regulator
Gas Line
9
).
2
Connect to
Gas Cylinder
75% N
2
25% CO
2
Gas
Cylinder