Location Of Parts; Before Using For The First Time - Summit SBC635MWKD Mode D'emploi

Top cover
Cabinet
Gas regulator valve
N /CO gas cylinder
2 2
N /CO tank supporter
2 2
Control board device
Compressor
chamber cover

BEFORE USING FOR THE FIRST TIME

The SBC635MWKD is designed for dispensing wine only, and is not recommended for
storing perishable foods such as meats or dairy products.
Before connecting the appliance to the power supply, leave it standing for 2 to 3 hours.
This allows the refrigerant to drain back into the compressor and reduces the risk of
malfunctions in the cooling system caused by shipping.
Clean the appliance thoroughly, especially the interior. (See Maintenance of the Wine
Dispenser.) Proper grounding must be ensured to reduce the risk of shock and fire. Do
not cut or remove the grounding plug!
Try not to open the door too often, especially when the weather is hot and humid. Once
you open the door, try to close it as soon as possible.
If possible, disconnect the power before changing a keg of wine.
Keep the unit out of direct sunlight.
Periodically, check that the wine dispenser seals well and that none of the contents
prevent the door from closing.

LOCATION OF PARTS

Tips for Saving Energy
4
Wine tower assembly
Upper cover guardrail
Drip tray
Display and control
panel
Evaporator
Ball valve
Wine keg
Door
Bottom pad
Caster