Cooper Lighting Solutions Streetworks TRU Tribute Instructions D'installation page 4

Installation Instructions – TRU Tribute
4c. Slipfitter Mount (Figure 4c.)
The integral slipfitter can be mounted on 2" (2-3/8"
● ●
O.D.) pipe. Set screws and a thru bolt are provided
to clamp it securely to the tenon. Thru bolt will
require a drilled hole thru the arm or tenon. Use the
slipfitter as a pattern to drill the thru hole. Secure
electrical leads from the drill path. Remove slipfitter
and clean burrs on tenon from drilled hole. Reinstall
the slipfitter. Remove the cover plate from slipfitter
and bring leads into compartment. Pull power supply
leads and the ground lead into the bottom half of the
slipfitter. Be sure the pivot retainer bolt is tightened
securely after aiming is accomplished. Tighten all
mounting bolts. (Figure 4c.)
4d. Trunnion Mount (Figure 4d.)
If the unit is provided with a trunnion which can
● ●
be mounted directly on a flat surface (Adapters
are available for installation on building fronts,
poles, crossarms, pipes, etc.) 14-3 SO cable is
recommended for making electrical connection. The
fixture is provided with a grommnet and a strain
relief (approximately 9/16" diameter). To maintain the
seal, screws in the strain relief must be retightened
whenever the seal is disturbed.
5.
Socket Setting Adjustment—Type II or Type III Only
(Figure 5.)
Socket is normally factory set to provide IES Type
● ●
II light distribution pattern. To obtain IES Type III
distribution, proceed as follows. (Figure 5.)
Loosen the two (2) hex head clamping screws
● ●
sufficiently for the socket to clear the indexing
screws.
Move socket bracket so that the indexing screws
● ●
engage appropriate indexing holes. See table
(Figure 5.) for socket position and resulting light
pattern.
Set screw
Torque to
15-20 foot-
pounds
Figure 4c. (Slipfitter Mount)
4
COOPER LIGHTING SOLUTIONS
Pivot Retainer Bolt Torque to
40-50 foot-pounds
3/8-16 x 4" Hex Head Thru
Bolt with lock nut
IB500022EN Installation instructions
3-8/16 Bolt
(Torque to 120-140 inch-pounds)
2" [51mm]
Figure 4d. (Trunnion Mount)
Socket Mount
Indexing Screw (2)
Clamping Screw (2)
Light Pattern
IES Type 250W Clear HPS
(5-3/4" LCL)*
II
III
N ote: * Light Center Length.
Figure 5.
3-1/2"
[89mm]
3"
[77mm]
5-3/8"
[137mm]
Mounting Holes
Indexing Hole
Socket Index Position
All other Clear
Lamp HID Lamps
(5" LCL)*
A B
C D