CHIEF iCFPAC2 Instructions D'installation page 10

iCFPAC2
1
1a
1
2
(G) x 2
(E) x 2
3
1b
1
2
(G) x 2
(E) x 2
4
10
x2
x2
(B)
(A)
x2
x2
(B)
3
(A)
INSTALL WALL PLATE TO WALL
WARNING:
FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS
COMPONENT CAN RESULT IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT!
It is the installer's responsibility to make sure the
structure to which this component is attached can
support five times the combined weight of all
equipment. Reinforce the structure as required before
installing the component.
Wood Stud Installation
1. Level wall plate outer section (B) and mark
locations of pilot holes.
2. Drill two 1/4" (6.35 mm) diameter pilot holes into
wood studs at marks.
3. Using socket wrench, install two hex head lag
screws (E) through two flat washers (G), shelf
arms (A) and wall plate outer section (B) into
wood stud.
Concrete Installation
1. Level wall plate outer section (B) and mark
locations of pilot holes.
2. Drill two 3/8" (9.53 mm) diameter pilot holes into
mounting surface.
3. Install two anchors (F) into pilot holes.
4. Using socket wrench, install two lag screws (E)
through two flat washers (G), shelf arms (A) and
wall plate outer section (B) into two anchors (F).
CAUTION:
Do NOT overtighten lag screws.
(F) x 2
Installation Instructions