Table des Matières
Publicité
4. (Figure 13) T urn the second rear hopper tube so that the
brace holes in the middle of the tube face up. Assemble
the ends of the rear hopper tube onto the ends of the
lower hopper side tubes. Fasten together using plastic
plugs (Z).
REAR HOPPER TUBE
(brace holes on top)
PLASTIC PLUG (Z)
LOWER
HOPPER
SIDE TUBE
5. (Figure 14) Place the assembled lower hopper tubes
into the bottom of the hopper bag
6. (Figure 14) Attach the ends of the lower hopper side
tubes to the inside of the upper hopper side tubes using
two 3/8" x 1/2" clevis pins (O) inserted from the inside,
and two 3/32" hair cotter pins (N).
LOWER HOPPER
SIDE TUBE
UPPER HOPPER
SIDE TUBE
3/32" HAIR
COTTER PIN (N)
3/8" x 1/2"
CLEVIS PIN (O)
HOPPER BAG
BOTTOM
ENGLISH
7. (Figure 15) Insert the bag frame strap into the stitched
sleeve along the front edge of the bag bottom.
8. (Figure 15) Assemble the bag frame strap to the lower
hopper side tubes using two 1/4" x 1-1/8" clevis pins
(P) and 3/32" hair cotter pins (N).
13
BAG FRAME STRAP
1/4" x 1-1/8"
CLEVIS PIN (P)
9. (Figure 16) Secure the bag corners around the lower
hopper side tubes by snapping the bag flaps to the bag
bottom on both sides.
14
SNAP
FIGURE 14
9
15
3/32" HAIR
COTTER PIN (N)
16
FLAP
Publicité
Table des Matières
