Agri-Fab 45-03261 Notice D'utilisation page 6

3. (Figure 3) Attach the brush assembly with the black
brush retainer to the left end of the brush shaft using
two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The
brush retainer marked with black ink must be placed to
the middle of the sweeper.
4. (Figure 3) Turn a wheel to rotate the brushes. (The
wheels drive the brushes in one direction only.) The
overlap bristles should be on the back side of the brush
as it rotates.
BRUSH RETAINER
MARKED BLACK
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
ENGLISH
5. Cut off the plastic tie that holds the height adjustment
tube in place.
6. (Figure 4) Assemble the R.H. hitch tube to the sweeper
housing using two 5/16" x 1-3/4" carriage bolts (C), and
two 5/16" nylock nuts (J). Do not tighten yet. Repeat
for the L.H. hitch tube.
3
5/16" x 1-3/4"
CARRIAGE BOLT (C)
7. (Figure 5) Fasten the hitch tubes together using two
5/16" x 3" hex bolts (A) and 5/16" nylock nuts (J). Do
not tighten yet.
5/16" x 3"
HEX BOLT (A)
6
5/16" NYLOCK NUT (J)
4
5
5/16"
NYLOCK NUT (J)