Operation Of The Wine Cooling Cabinet - Caso Germany 630 Mode D'emploi

•
Do not install the device in a location that is exposed to direct sunlight or near heat sources
(oven, radiator, heater, etc.). Direct sunlight can affect the acrylic surface and heat sources
can negatively influence the energy consumption. Extremely high or low ambient
temperatures can also result in limited functionality.
The power outlet must be easy to reach to ensure that the power cable can be easily
unplugged in an emergency.

Operation of the Wine Cooling Cabinet

We recommend installing the device in a location with an ambient temperature of 18-26°C. An
ambient temperature above or below these values can negatively influence the performance of the
device. Example: Operating the device in extremely hot or cold conditions can result in excessive
temperature fluctuations inside the device.
The temperature can fluctuate depending on the interior light being switched on or off or the bottles
being placed on the top, middle or bottom shelf.
Close the door immediately after inserting or removing wine bottles.
Any of the wine shelves can be removed to accommodate larger bottles.
Using the push buttons on the display panel:
You can set the required temperature by using the buttons next to the display.
Use the buttons and
of 7-18°C. The bottom area with the shelf inserts is identified as "lower" and its temperature can be
set in the range of 10-18°C.
The temperature can be adjusted in steps of 1°C. Use the button marked "Licht" (Light) for
switching the internal light on and off.
Screw
marked "upper" to set the temperature for the two top shelves in the range
Door handle
13