• After at least 10 minutes, plugging the appliance into the wall outlet,
than place wine bottles or beverages in the appliance.
► Only remove the blue protective film shortly before setting up the device
in the location where it will be used, to prevent scratches and dirt
accumulations.
11.4 Disposal of the packaging
The packaging protects the device against damages during transit. The
packaging materials are selected in accordance with environmentally
compatible and recycling-related points of view and can therefore be
recycled.
Returning the packaging back to the material loop saves raw materials
and reduces the quantities of accumulated waste. Take any packaging
materials that are no longer required to "Green Dot" recycling collection
points for disposal.
► If possible, keep the original packaging for the device for the duration of
the guarantee period of the device, in order that the device can be re-
packaged properly in the event of a guarantee claim.
11.5 Setup
11.5.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the
setup location must fulfil the following prerequisites:
• Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded.
• Locate the appliance away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
• Ambient temperature below 0°C or above 38°C will hinder the
performance of the appliance.
• This unit is not designed for use in a garage or any other outside
installation.
• Do not set up the device in a hot, wet or extremely damp environment
or near flammable material.
• The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 8 cm around the appliance.
• Do not cover up any openings on the device and do not block these off.
caso WineCase 6
Please note
Please note
30