ANSMANN Racing Wheel Radio W6 2.4 GHz Instructions De Service page 9

12.06 E. point
Function explanation:
Use this function when performing left and right steering angle
adjustments, throttle high side/brake side amount adjustment, and
channel 3 servos up side/down side operation amount adjustment
during linkage setup. Used to correct the steering angle of adjusting
left and right steering angles, when there is a difference in the left
and right turning parameters.
Parameter specification:
CHANNEL: Channel number, from 1 to 3.
100%: Output value. Adjustment range: 0∼120%
(initial value is 100%).
: Left, forward or right, back
(select by steering wheel or throttle trigger)
12.07 TRIM
Function explanation:
Use this function to adjust the neutral position of the steering, throttle
and channel 3 servos.
Parameter specification:
CHANNEL: Channel number, from 1 to 3
R30: Steering or 3rd channel right side, adjustment range:
0 ∼ 30 (initial value is NOO)
L30: Steering or 3rd channel left side, adjustment range:
0 ∼ 30 (initial value is NOO)
F30: Throttle forward, adjustment range:
0 ∼ 30 (inital value is NOO)
B30: Throttle backward, adjustment range:
0 ∼ 30 (initial value is NOO)
9
3-Channel Wheel Radio W6 2.4 GHz
Operation:
Press the"ENTER"button and turn to select the TRIM option. The
selected function will be blinking. Select the channel by turning the
"ENTER" button, and then press the "END" button (now the icon will
be blinking). Turn the "ENTER" button to adjust the rate. After this,
press the "END" button to finish the setting. The rest can be done in
the same way. After finishing the setting of three channels, press the
"ENTER" button to return to menu screen.
Press "BACK" to return to the openning screen.
Operation:
Press the "ENTER" button and turn to select the TRIM option. The
selected function will be blinking.
Select the channel by turning the "ENTER" button, and then press
the "END" button (now the percentage will be blinking). Turn the
"ENTER" button to adjust the rate. After this, press the "END" button
to finish the setting. The rest can be done in the same way. After
finishing the setting of three channels, press the "ENTER" button to
return to menu screen.
Press: "BACK" to return to the opening screen.