Throttle Control; Fail Safe Function - ANSMANN Racing Wheel Radio W6 2.4 GHz Instructions De Service

13.02 Throttle control

Function explanation:
This function is to control the speed. When you pull the throttle
trigger back, the car will accelerate forward (see the picture).
When you push the throttle trigger, the car will put on the brakes or
accelerate back (according to the different ESC), (see the picture).

14. Fail Safe Function

1. Function
Fail safe aims to prevent out-of-control driving of RC car or RC boat.
If the receiver is not able to receive any signal from the control to the
throttle, the parameter of the throttle on the receiver will turn back to
its original setting.
2. Setting
a. Turn on the transmitter switch.
b. Turn on the receiver switch, the LED will be lighting.
c. Adjust transmitter's throttle, make the car/boat to stop or
flame-out, then keep still.
d. Press the „Setting" button on the receiver (as the picture below),
the LED will be flashing, then stop after about 3 seconds, which
means setting is finished.
Instruction Manual
Operation:
To control it by pushing and pulling back the throttle trigger after the
power is on.
3. Testing
a. Turn on the transmitter switch.
b. Turn on the receiver switch.
c. Turn off the transmitter switch.
d. Servo of throttle will turn back to its original setting automaticlly.
e. Setting is successful, if above procedures are finished completely.
12