Eurostove 65 S-line Mode D'emploi page 162

Room air recir-
culation blow-
er continues to
run when the
stove is cold.
Ash on the
floor around
the stove
Stove in con-
stant mode,
the display
shows: "Eco"
Display shows
"SERV"
Display shows
"Atte"
4
162
Electronic printed circuit
board is defective.
Flue pipes are not air-
tight
Broken, worn or dam-
aged door seal
The room temperature
desired by the user has
been reached
No error. The stove re-
quires a service every 900
hours of operation. The
stove will simply continue
to work.
An attempt is being
made to start the stove
while it is still in the cool-
ing-down phase.
Replace the printed circuit board Only to
be done by a Eurostove-approved techni-
cian
Only to be done by an approved flue
fitter: Flues that are not airtight can harm
your health. Seal the pipe fitting immedi-
ately (use Loctite 598 or equivalent prod-
uct) and/or replace the pipes.
Replace the seal. Only to be done by a
Eurostove-approved technician
This is not an error. The stove is working in
eco mode. This mode can be changed with
the remote control
The stove requires a service. Contact a
Eurostove-approved service technician. The
technician will carry out a service on the
stove and reset the notification.
Wait until the cooling down phase has
been completed before trying to reignite
the stove.