Eurostove 65 S-line Mode D'emploi page 157

b. Push the rear of the heat shield down (figure 24).
c. Push the left side up in the direction of arrow 1 (figure 25) and turn the
right side downwards in the direction of arrow 2 (figure 25).
d. Then remove the heat shield from the combustion chamber.
3. Now remove the inner plates from the hearth.
a. Remove screws 1 and 2 (figure 26).
b. Use a screwdriver to pry the plating loose (figure 27).
c. Pull the plating forwards towards the door and remove it from the hearth.
Repeat for the plating on the right side (figures 28 and 29).
d. Remove the panel at the rear of the hearth by pulling it forward. Use a
screwdriver if necessary. Remove the panel from the stove (figure 30).
e. Remove the panels on the left and right sides. Slide the side panel about
2 cm forwards towards the door past the part marked with the arrow
(figure 31).
f. Now pull the top of the panel to the middle of the hearth and remove it
from the stove. Repeat this procedure to remove the panel on the right
side of stove from the hearth (figure 32).
g. Remove the base plate on the right. Pry it upwards with the aid of a
screwdriver and remove it from the stove (figure 33).
h. Remove the base plate on the left by sliding it horizontally 3 cm to the
right and then lifting it out of the hearth (figures 34 and 35).
4. Clean the hearth, the area beneath the brazier and the plating with a brush
and a vacuum cleaner.
5. After cleaning all the parts that have been removed, fit them back into the
hearth in reverse order.
6.7 CHECK THE SEAL ON THE FIRE DOOR
Check the door seal for leaks and damage at least twice a year; the first time before
the season starts. If necessary, have the door seal replaced by a Eurostove-approved
technician. Only use original Eurostove spare parts.
6.8 CLEANING THE PELLET HOPPER AND AUGER
Clean the pellet hopper and auger once a month.
1. Remove the protective grille from the pellet hopper.
2. Empty the pellet hopper.
3. Clean the pellet hopper and the visible part of the auger with a vacuum
cleaner (figure 36).
4. Refit the protective grille.
5. Fill the hopper with pellets.
6.9 CLEANING THE PELLET SUPPLY PIPE
Clean the pellet supply pipe once a week with a stiff round brush (figure 37). The
pellet supply pipe is located in the stove's combustion chamber. Creosote can build
up in the supply pipe and contaminate it to such an extent that it can get blocked
by pellets.
4
157