Special Safety Instructions; Putting The Device Into Operation - BOMANN EM 440 CB Mode D'emploi

WARNING:
This warns you of dangers to your health and indicates possible injury risks.
CAUTION: This refers to possible hazards to the machine or other objects.
NOTE: This highlights tips and information.
WARNING:
• Attention, the cutting blades are extremely sharp! Handle with extreme care when
using the appliance and when cleaning the blades!
• Warning! The blades are very sharp. Before inserting or removing the blades, always
remove the mains plug.
• Do not leave the knife unattended when it is ready to operate.
• Never immerse the basic device in water.
• Always remove the mains plug before cleaning the device.
• Do not cut any frozen food or bones with the electric knife.
• Do not operate the knife for more than 5 minutes without a break.
• Remove the motor device and the accessories from the box. Also remove any pa-
ckaging materials that may be present.
GB
• Wipe all the parts with a moist cloth to remove all the dust that may have deposited on
and in the device during transport. Then mount the device again by proceeding in the
opposite order.
WARNING:
Please be particularly careful when handling the knives. There is a danger of
injury. Only hold the blades as near to the ends as possible or by the plastic
handling surfaces.
• Assemble the blades as shown in illustration 1 (ABB 1).
• Insert the ends of the knives into the retainer on the motor device.
• Press the blades in the direction of the motor device until the ends are felt to lock in
place. Check that they are fi rmly attached.
• Insert the plug in a duly installed 230 V/50 Hz socket.
34
05-EM 440 CB 34

Special Safety Instructions

Putting the device into operation

14.11.2006, 14:29:09 Uhr