Sanding Cuts And Sandpaper - American Sanders Clarke EZ Sand Manuel D'utilisateur

ENGLISH
EN

Sanding Cuts and Sandpaper

Initial Cut
The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. Use a
course (20-36 grit) grain abrasive.
Final Cuts
The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60-80
grit) grain abrasive.
If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive
(80-100grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close the
pores on a wood floor making admission of a stain difficult.
If glazing or burning should occur the abrasive has dulled and must be replaced.
Grain
20 grit
36 grit
60 grit
80 grit
100 grit
120 grit
-10-
Use
For removing gross imperfections and restoring
evenness to old flooring. To remove buildup of
paints and varnishes
For the first sanding of new flooring (maple, oak).
For removing minor imperfections and finishes
from old flooring.
For clean-up from initial cut 36 grit.
For final sanding of certain hardwoods. For
clean-up of cuts (60 grit).
For final sanding of certain hardwoods and
conifers where a smooth surface is desired.
For final sanding of certain hardwoods and
conifers where a smooth surface is desired.
For leveling after initial finish coat.
Clarke
Grado estándar
Pieza #/Ctdad
Part #/Qty.
54082A
54081A
54080A
54079A
54078A
53886A
®
American Sanders Operator's Manual (EN) - EZ Sand
Standard
Grade