Bartscher 700207G Mode D'emploi page 29

LED indicators
LED cooling indicator
This indicator comes on when the cooling device is active, goes off
when the desired internal temperature is reached, and flashes during
.
delays
LED defrost indicator
This indicator comes on during defrost, goes off when the defrost
process is completed, and flashes during extended defrost.
Setting the desired temperature (desired value)
o The temperature in the device can be regulated to between 2 ° C and 10 ° C.
o To set or change the desired value:
press the button marked
increase or reduce the value using the buttons marked
confirm the value entered by pressing the button marked
o If no button is pressed in the next 10 seconds, the digital display will show the
temperature inside the device.
Turning lighting on/off
•
The device is equipped with 2 LED lighting strips along the sides of the door frame.
•
The internal LED lighting can be activated by pressing the button marked
•
To turn the lighting off, press the button marked
Automatic defrost
The device's automatic defrost cycle runs 4 times every 24 hours.
Manual defrost
If you wish to defrost the device outside its automatic defrost cycle, press and hold the
button marked
until the defrost cycle is completed. The LED defrost indicator will go off after defrost is
finished and the next defrost cycle will begin in 6 hours.
- 28 -
;
the set value will begin flashing
for 6 seconds. The LED defrost indicator will come on
;
and
.
again.
;
.
and will flash