Lenze Global Drive Keypad E82 Instructions De Montage page 66

7 Parameterisation 8200 vector/8200 motec
Change and save parameters
Step
1. Select menu
2. Change to the code level
3. Select code or subcode
4. Change to the parameter level
5. When SHPRG is displayed,
inhibit the controller
6. Change parameters
7. Accept the changed parameter
Display of SHPRG or SHPRG
8. Enable the controller, if
required
9.
Change to the code level
10. Change further parameters
66
Key sequence
z y Z Y
Z
y z
V
S
Z Y
A
y z
B
T y
T z
p T V
p
−
Display
U
V
A
V
B
l
Action
Use the arrow keys to select the desired
menu
Display of the first code in the menu
Display of the current parameter value
The drive coasts
Move cursor below the figure to be
changed
Change of figure
Quick change of figure
Confirm change to accept the parameter
Display "OK"
The parameter has been accepted
immediately
The drive operates again
Display of the operating level
Display of the code with changes
parameter
Restart the "loop" with step 1. or 3.
EDK82ZBC DE/EN/FR 4.0