Safety Instructions - Velleman CLP4 Notice D'emploi

CLP4 – 4 LED PANELS WITH REMOTE CONTROLLER
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying a Velleman product! Use these 4 LED panels to create the most amazing visual effects. Please
read the manual thoroughly before bringing this device into service. If the device was damaged in transit, don't install or
use it and contact your dealer.

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Keep the device away from heat sources, water and humidity.
• Wipe the device regularly with a lint-free cloth. Do not use alcohol, solvents or water. Disconnect the unit from
mains before cleaning.
• Do not remove the cover and never touch electrical parts inside to reduce the risk of electrical shock.
• Place the panels on a flat, dry and clean surface only.
• These panels are intended for indoor use only.
• Keep the device away from children and unauthorised users.
3. Installation
• The units can be placed on a flat surface or be wall-mounted.
• First determine the mounting location and height. We strongly recommend mounting the unit on a structural wall
to avoid injury to persons and damage to unit or mounting surface.
• Drill two holes 70mm apart. Only drill holes that can accommodate the provided screws. Insert nylon plugs prior to
installing the screws.
4. Use
• Insert the adapter plug into the input at the bottom of the master unit. Use the included cables to link the 4 panels
between them. Connect the adapter to the mains.
• Switch the panels on or off using the remote controller.
• Select the desired colour by pressing a colour button.
• To use the sound-activated mode, press the desired colour and then press SENSO. The light effect will react to
surrounding music or noises.
• In auto mode, you have the choice between fading colours and flash effects (FLASH).
• For adjusting the panels without remote controller, press the "MANUAL ADJUSTMENT" button on the backside of
the master panel. Hold the button pressed to switch the panels on or off. Press the button and choose your colour.
CLP4_v3 3 VELLEMAN