WLD-TEC gasprofi 1 micro Mode D'emploi page 35

• No ignition spark / LED Burner head "HOT / BHC" flashes but the burner head
is clean
Check if the ceramic electrodes are in good condition. In some cases
the electrodes may break. To check move the ends of the
electrodes. If they are not moving they should be okay. If they are
moving more than 0.5 mm the electrodes are broken. The electrodes
can be dismantled and changed by the user (see paragraph 6.1).
• The burner shuts-off due to overtemperature frequently
In case of overtemperature increase the air ventilation or change the
operation site.
• The IR-Sensor cannot be activated
It is possible to adjust the sensor range to 0 mm or more than 70 mm.
Then the IR-Sensor is out of range and cannot be activated.
In that case, increase or decrease the IR-Sensor range at the function
for adjusting the IR-Sensor detection range (see paragraph 3.6)
• Green LED "Button", "Standard" or "Start-Stop" blinks 2x
Ignition failure (see paragraph 5.1).
• Green LED "Button", "Standard" or "Start-Stop" blinks 3x
Flame failure (see paragraph 5.2).
• Green LED "Button", "Standard" or "Start-Stop" blinks 4x
Overtemperature (see paragraph 5.3).
• Green LED "Button", "Standard" or "StartStop" blinks 5x
This message indicates that the burner head is removed or not
mounted correctly. Further operation is possible after the burner head
is reinstalled (see paragraph 5.4).
• Amber LED "Burner head HOT / BHC" (8) is on permanently
Residual heat display is active. Attention: DO NOT TOUCH the
burner head (see paragraph 4.1).
Service address:
WLD-TEC GmbH
Production & Service
Halle-Kasseler-Str.49
37318 Arenshausen
Phone: +49 (0) 36081 68940
Fax: +49 (0) 36081 68942
Email: sales@wld-tec.com
Internet: www.wld-tec.com
EN
35