Safety Symbols And Safety Functions; Residual Heat Display; Burner Head Control (Bhc); Automatic Unit Switch Off - WLD-TEC gasprofi 1 micro Mode D'emploi

Masquer les pouces Voir aussi pour gasprofi 1 micro:

Table des Matières

Les langues disponibles

When the required IR-Sensor detection range is reached press the function knob (1). The

adjusted IR-Sensor detection range is now saved and the application program returns to

SENSOR StartStop.

4. Safety symbols and safety functions

The safety LED's appear during usage to warn the user of potential hazards.

The LED „Burner Head Hot / BHC"

LED shines, DO NOT TOUCH the burner head. This can cause serious burns.

Even after switching-off the unit, the residual heat LED remains "on" till the burner head

is cooled down.

Disconnecting the power supply or removing the power cord will clear

the residual heat display even if the burner head is still hot.

If the burner head is clogged, the amber LED "Burner Head HOT / BHC" (8) will flash

you have to clean the burner head (see paragraph 5.5), otherwise the maximum

burning time in the operating mode "Button" and Pedal "Start-Stop" is limited to 30

seconds (see paragraph 6.1). If burning times longer than 30 seconds are required

in case of a clogged burner head, the operating mode "Pedal Standard" can be used

without time limit.

The unit switches itself off automatically after 4 hours if it is not used during this time.

The button & IR-Sensor programs switch off after 10 minutes. Even in the event of a fault,

the device shuts off after 4 hours and the error display goes out (see paragraph 5). For

further operation, switch the unit on again.

For flame ignition, activate the IR-Sensor (6) by passing your hand over it twice within a

time range of 1 sec. After the first activation the LED Sensor blinks fast for 1 sec. Within

this time range the IR-Sensor (6) needs to be activated a second time to ignite the flame.

(8) indicates a hot burner head. As long as the

Table des Matières

Table des Matières