Franke AQCT0027 Notice De Montage Et De Mise En Service page 7

☞
Drill with a low rotation speed in order to protect the tiles.
10.15 Drill holes in accordance with these markings.
Insert the wall plugs.
☞
Use special wall plugs (not part of the delivery scope), depending on the consistency
of the wall.
10.16 Pull the extension cable for the power supply (not part of the delivery scope, see
accessories, chapter
10.17 Establish the plug-in connection between the sensor and the extension cable.
10.18 Pull the extension cable for the AQUACONTACT sensor through the empty conduit.
10.19 Establish the plug-in connection between the AQUACONTACT sensor and the
extension cable.
10.20 Fasten the cover plate.
☞
Important!
The solenoid valve must be connected before the power supply is connected.
☞
The battery compartment or power supply and extension cable are not part of the
scope of delivery (see Accessories,
10.21 Connect the extension cable for the AQUACONTACT sensor (l) to the solenoid valve
(f).
☞
If you are using a wall-mounted power supply unit, it must be installed around 3 m
away from the shower.
10.22 Connect the extension cable for the power supply (i) with
– a battery compartment (h)
or
– a wall-mounted power supply unit (k).
☞
If the battery charge state is low, the LED flashes in a 20 second cycle.
20) through the empty conduit.
chapter 20).
7