Wall Mounting For Your Sound Bar; Remarks - THOMSON SB100BT Mode D'emploi

Wall mounting for your sound bar

Please tear off the sticker, Use the wall attachment
kit to mount your sound bar on the wall.
Wall attachment kit
1. 2 wall brackets
2. 8 attachment screws (for sound bar with bracket)
3. 8 EVA cover the screw
4. 2 long screws
5. 2 wall anchors
You will need:
1. Electric drill
2. Screwdriver
3. Pencil
4. Spirit level
Note: Use the spirit level to ensure the wall mount plate are both horizontal.
1. Tear off the sticker on back plate, screw in the 4 screws with bracket to the sound bar, and take
the EVA cover the screws.
2. Mark the holes to be drilled.
3. Drill holes at the marketed points then insert the wall anchors.
4. Screw in the 2 screws to the wall, then attach the sound bar and make sur it is stable.

Remarks:

Don't discard the electrical and electronic appliances in the regular waste disposal.
• Take them to a collection point.
• Some components in these appliances may be hazardous to health and the
environment.
• In order to save energy when the unit has no sound output for a while, the unit will be switched to
stand-by automatically. It can be switched ON by using the POWER selector again.
• If there is an incoming call while SB100BT/SB200BT is connected to your cell phone for music
playback, it will pause at once when you answer the call and resume after the call ended. (Sometimes
it will pause after end the call, it depend on your cell phone.)
• The Bluetooth® word, mark and logo are registered trademarks owned by Bluetooth SIG, Inc. and
any use of such marks by Bigben Interactive is under license. Other trademarks and trade names
are those of their respective owners.
• THOMSON is a trademark of TECHNICOLOR SA or its affiliates used under license to Bigben
Interactive.
- EN 7 -