Mendip Stoves Churchill 8 Mk.4 Guide D'utilisation Et Mode D'emploi page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING YOUR STOVE - THE MK.4 AIR CONTROL LEVER
The Universal air controller provides air control for the whole stove from a single lever. The Lever has two key operations
Increased Air Supply
LEFT: PRIMARY AIR
Whatever position the control is set at, the lever
can have either minimum combustion air or
maximum combustion air.
LIGHTING YOUR STOVE FOR THE FIRST TIME
Before lighting your stove for first time make sure you have read this manual fully and acquainted
Ensure that you have allowed sufficient time for the heat resistant sealant to cure.
The heat-resistant paint on your stove will cure and harden the first time you light your appliance.
The curing process produces a good deal of smoke and odour, it is therefore important that the first time you light your
stove the room should be well ventilated.
During the process it is important to open and close the stove door periodically (every 30mins) during the first couple of
firings therefore preventing the door seal cord around the door from sticking and coming away from the door. Once the
heat-resistant paint has hardened the smell will disappear.
Your stove is NOT designed to be used with the door open, the stove door must be kept closed except when lighting the
stove, adding firewood or removing ash in order to prevent flue gases from escaping.
Use of Fire lighters
Quality Firelighters should be used when lighting your stove. (Never use mentholated spirit, petrol or other flammable liquids).
Lighting your stove with firelighters will be more reliable and easier than using paper. Lighting your fire with paper results
in excess smoke, more ash and possible blackening of glass.
Moving the control
lever in and out
Sliding the control
lever in reduces and
out increases the total
amount of combustion
air in the stove.
yourself with the controls of this appliance.
12 of 36
Decreased Air Supply
Moving the control lever from left to right:
By moving the control lever to the left increases
the primary air mix and moving to the right
increases secondary air (airwash) mix .
RIGHT: SECONDARY AIR

Publicité

Table des Matières
loading

Table des Matières